Contact Us | Home | Return to Options Page  
 
Equiguard - Reimbursement Schedule
Equiguard offer both a flat rate and a customized reimbursement for contractors.

Equiguard Expanded Reimbursement Schedule (ERS) has a liberal part markup and labor allowances based on specific needs of the contractor. Contact us for additional information on regarding the customized ERS program. The following is provided for under the flat rate program:
Labor Allowances
Furnace - Oil/Gas or Air Handeler or Boiler Hours Residential Hours Commercial
Fan & Limit Control - 4 or More Wires 1.5 2.5
Main, Auxiliary, or Spill (Roll Out) Limits 2 - Wire 1 1.5
Door Switch 1 1.5
Fan Center (Complete) 1.5 2.5
Burners 4-6 Pieces 1.5 2.5
Burners 1-3 Pieces 1 1.5
Inducer/Combustion Assembly 1 1.5
Inducer Motor and/or Wheel 1.5 2.5
Gas Valve 1.5 2.5
Ignitor - Hot Surface or Spark Ignition (Electrode) Sealed Combustion 1.5 2.5
Ignitor - Hot Surface or Spark Ignition (Electrode) Non-Sealed Combustion 1 1.5
Oil Nozzel or Pilot Orfice 1 1.5
Fuel Pump - Oil System 1 1.5
Fan/Main control or Ignition Module 1 1.5
Blower Motor up to 1 hp or Bracket/Mount 1 1.5
Blower Motor 1.25+ hp Belt or Direct - 4.0
Bearing Assembly (1 set) up to 1 hp or Shaft 1.5 2.5
Bearing Assembly (1 set) 1+ hp or Shaft - 3.5
Pully or Belt 1 2
Heating Element Assembly 1.25 2
Primary and Secondary Heat Exchanger 6 8
Primary or Secondary Heat Exchanger 4 5.5
Thermocouple or Thermal Fuse 1 1.5
Fan, Sequencer, or Other Relay 1 1.5
Transformer 1 1.5
Misc Wiring 1 1.5
CAD Cell 1 1.5
All Fuel Control 1 1.5
Flame Sensor 1 1.5
Flue Damper (Boiler Only) 1 1.5
Boiler Pump (Circulator) 2.5 3.5
Couplers 1.5 2.5
Water Heaters Hours Residential Hours Commercial
Tank Rplacement (<=50 Gallons) 2.5 3.5
Tank Replacement (>=51 Gallons) 3.5 5
Pressure Relief 1 1.5
Condensor/Heat Pump Hours Residential Hours Commercial
Drier and Compressor 1-3 tons 3.5 5
Drier and Compressor 4-5 tons 5 7
Drier and Compressor 6-10 tons - 8
Drier and Compressor 11+ tons - 1hr. per ton
Contactor 1 1.5
Accumulator/Receiver 2.5 3.5
Leak/Restriction 2 3
Low or Hi Pressure Switch 2 3
Service Valve - Replacement 2.5 3.5
Reversing Valve 2.5 3.5
Defrost Sensor/Ambient Sensor 1 1.5
Defrost Board/Control/Timer 1.5 2.5
Defrost Relay 1 1.5
Crank Case Heater 1 1.5
Fan Blade 1 1.5
Motor 1.5 2.5
Reversing Valve Coil 1 1.5
Capacitor - Run/Start/Split/(Start Assist) 1 1.5
Condensor Coil 4 5.5
Time Delay Relay 1 1.5
/Recovery Time 0.5 1
Overload - External of Compressor 1 1.5
Coil Hours Residential Hours Commercial
Metering Device/Check Valve 2 3
Expansion Valve 2.5 3.5
Replacement Valve 3.5 5
Liquid Line Solinoid Valve 1.5 2.5
Drain Pan 2.5 3.5
Leak in Coil (Evap or Cond) 2.5 3.5
Leak in Factory Joints or Valves 1.5 2.5
Selector Switch 1 1.5
Commercial Refrigeration Hours Residential Hours Commercial
Drier and Compressor .10-1 ton - 3
Drier and Compressor 1.5-3 ton - 5
Drier and Compressor 4-5 ton - 7
Contactor - 1.5
Accumulator/Receiver - 3.5
Low or Hi Pressure Switch - 2
Service Valve - Replacement - 3
Reversing Valve - 4.5
Defrost Sensor - 1.5
Control/Timer - 2.5
Defrost Relay - 1.5
Crank Case Heater - 1
Fan Blade - 2.5
Motor - 1.5
Capacitor - Run or Start or Split or (Start Assist) - 1
Overload - External of Compressor - 1.5
Leak in Coil (Evap or Cond) - 3.5
Leak in Factory Joints or Valves - 2.5
Replace Coil - 5
Restriction - 3
Thermostat - 2

1111 Pasquinelli Drive Suite 400, Westmont, Illinois 60559 (USA)
Toll-free Telephone: (800) 886-9363    Facsimile: (630) 325-7126
Email: equinfo@equiguard.com